FL Roofing LicenseLicenseCCC1331782 Hablamos Español
  1. Home
  2. Blog
  3. TPO vs. Modified Bitumen: Which Flat Roof Is Better?
Roof Tips Blog · Roof Types

TPO vs. Modified Bitumen: Which Flat Roof Is Better?

They're the two flat roofs we install, and they're built in opposite ways. One is layers of asphalt-based sheets. The other is a single white sheet. How to choose between them for a home, a condo or a commercial building.

  • Hablamos Español
  • Licensed & insured · CCC1331782
  • Mon–Fri 8–5 · Sat 9–2

100% free · No obligation

Schedule Your FREE Roof Estimate / Inspection

Full re-roof quote, a repair, or just an inspection. Pick one and we'll call to set a time.

We'll call you back in English or Spanish during business hours: Mon–Fri 8 AM–5 PM, Sat 9 AM–2 PM.

Google 4.9 65 reviews
BBB A+ Accredited Business
GAF Certified Commercial Contractor

The short answer

Neither is better everywhere. Modified bitumen is the usual choice for porches, additions and other small roofs on homes, because it has more than one layer and is easy to fit around corners. TPO is the usual choice for big, open roofs on commercial and condo buildings, because it's white and covers a large area with few seams.

What's the difference between TPO and modified bitumen?

Both give you a continuous waterproof surface. They get there in different ways.

Modified bitumen is asphalt blended with rubber or plastic, so it flexes instead of cracking. It comes in rolls about three feet wide and goes down in two or more layers. The top sheet is covered in granules, like a shingle, to block the sun. We install it hot-mopped, which means each sheet is set in a layer of hot asphalt that bonds it to the one below.

TPO is a single plastic sheet, usually white. It's made as three layers in one: a base, a reinforcing fabric in the middle, and a top layer built to take sun and heat. It comes in rolls up to 10 feet wide and goes over insulation board, and the seams are welded together with hot air. We install 60 mil, which is 60 thousandths of an inch thick.

Modified bitumenTPO
Made ofAsphalt blended with rubber or plasticPlastic (thermoplastic polyolefin)
LayersTwo or moreOne
SeamsLaps sealed in hot asphaltWelded with hot air
SurfaceGranules, in several colorsSmooth. White, tan or gray
Under footTougherNeeds walk pads on busy paths
Corners, pipes and postsEasier to fitEach one is welded by hand
In the sunAbsorbs more heatWhite reflects more heat
Usual fitHomes, porches, small roofs, roofs with foot trafficLarge, open roofs
Typical life hereAbout 15 to 25 yearsAbout 15 to 25 years

Which is better for a house?

Most of the time, modified bitumen. Flat roofs on homes are usually small and full of details: a porch with posts, a Florida room against a wall, a garage with a pipe or two. Four things favor it there.

  • It fits tight spaces. Narrow sheets are easy to cut and fit around corners and posts. With TPO, every one of those details is welded by hand, and the details are where TPO roofs leak.
  • It has more than one layer. If a branch or a dropped tool cuts the top sheet, there's another sheet under it.
  • It joins the main roof simply. Where a porch roof runs up under the shingles or tile of the house, asphalt-based sheets make that joint without special parts.
  • It looks like a roof. The granule surface comes in colors that sit well next to shingles. TPO is bright white and looks commercial, which matters if you can see the roof from a window or the street.

TPO makes sense on a house when the whole home has a flat roof and that roof is large and open, or when a cooler roof surface matters most to you.

Which is better for a commercial or condo building?

Usually TPO. On a plaza, warehouse, office or condo building the roof is big and open, and that's the kind of roof TPO suits.

  • Fewer seams. Wide sheets cover a lot of roof, and fewer seams means fewer places to leak.
  • A cooler roof. The white surface reflects much of the sun's heat. On a large building, that's a lot of roof not heating the space below.
  • Slope can be built in. TPO goes over insulation board, and tapered boards add slope toward the drains.

Modified bitumen is still the better pick on some commercial roofs: small ones, roofs crowded with equipment, and roofs that someone walks on every week.

One warning about TPO. Cooking grease breaks it down, so tell us if a kitchen exhaust fan vents onto your roof.

Which lasts longer in the Florida sun?

About the same. Both last about 15 to 25 years here. These four things matter more than which one you pick.

  • Drainage. Water that stands for days wears out either roof, and some roofing warranties don't cover damage caused by ponding.
  • Thickness and layers. With TPO, a thicker sheet has more material to wear away. 45 mil is the budget sheet, and we install 60. With modified bitumen, it's the number of layers.
  • The details. Both roofs leak at drains, walls, pipes and edges long before they leak in the open.
  • Foot traffic. AC service visits wear paths into any flat roof.

In a storm, neither roof is rated in miles per hour. Flat roofs are rated by uplift pressure, and each system's Florida Product Approval lists the pressures it passed in testing. Wind pulls hardest at the corners and edges of a flat roof, so that's where either system is fastened most closely.

Which is easier to repair?

Modified bitumen, by a little. A cut or a blister is repaired with a new piece of the same material bonded over it, and an older roof still takes a patch well.

TPO is repaired by welding a new piece of membrane over the damage. On a newer roof that's quick. As the sheet ages, its surface has to be cleaned and prepared before a weld will hold, and a badly worn sheet won't take a patch well.

Either roof can only be patched if it's dry underneath. Wet insulation or soft wood under the surface means a bigger fix than a patch.

What about EPDM and PVC?

You'll see both names when you read about flat roofs.

EPDM is a black rubber sheet. Its seams are glued or taped, not welded. It's common in colder parts of the country, where a black roof that soaks up heat is welcome. Here it rarely makes sense.

PVC looks like TPO and is welded the same way. It handles grease and oils better than TPO, so it's often used over restaurants. It usually costs more.

We install TPO and modified bitumen.

So which one should I choose?

Match the roof to the building.

Your roofUsually the better fit
Porch, Florida room, garage or addition on a houseModified bitumen
A roof you can see from a window or the streetModified bitumen
A big, open roof with few pipes or unitsTPO
A building that runs the AC all dayTPO
Lots of rooftop equipment and service trafficModified bitumen, or TPO with walk pads
A roof that holds waterFix the drainage first, then either one

Whichever you choose, ask four things before you sign: how thick the TPO is or how many layers of modified bitumen you're getting, how the roof will drain, how the seams are checked, and what the system's Florida Product Approval number is. There's more on our TPO Roofing and Flat Roofs pages.

How Bravo's Roofing can help

We install both, on homes and on commercial and condo buildings across Palm Beach and Broward County. We look at the roof's size, drainage and foot traffic before we recommend one. Your quote comes with the system's Florida Product Approval number. Our workmanship warranty on flat roofs is 7 years, plus the manufacturer's material warranty. Estimates are free. Hablamos español.

Lifespans are what we see on South Florida roofs, not a guarantee for any one roof. Information is current as of November 2026.