FL Roofing LicenseLicenseCCC1331782 Hablamos Español
  1. Home
  2. Services
  3. Roof Ventilation
Roof Ventilation

Roof & Attic Ventilation in Palm Beach & Broward County

A hot, stale attic heats your home and works your AC harder. We balance the air coming in with the air going out, and add the right vents, including Solar Star solar attic fans.

  • Hablamos Español
  • Licensed & insured · CCC1331782
  • Mon–Fri 8–5 · Sat 9–2

100% free · No obligation

Schedule Your FREE Roof Estimate / Inspection

Full re-roof quote, a repair, or just an inspection. Pick one and we'll call to set a time.

We'll call you back in English or Spanish during business hours: Mon–Fri 8 AM–5 PM, Sat 9 AM–2 PM.

Google 4.9 65 reviews
BBB A+ Accredited Business
GAF Certified Commercial Contractor
Why It Matters

Why Your Attic Needs to Breathe

On a summer afternoon, a South Florida attic gets far hotter than the air outside. Ventilation gives that heat a way out.

Shingle roof ridge with a roof vent
  • That heat pushes down through the ceiling and warms the rooms below
  • In most Florida homes the AC ducts run through the attic, so a hotter attic means the AC works harder
  • Moisture that gets into the attic needs a way out too. Trapped, it can mean damp insulation and mold.
  • Shingle manufacturers call for proper attic ventilation
  • It takes two parts: intake vents low on the roof to let air in, and exhaust vents high on the roof to let it out. One without the other doesn't work.
Types of Vents

Passive & Active Ventilation

Passive vents let heat rise out on its own. Active vents use a fan to pull it out.

Soffit Vents

The intake. These vents under the eaves let outside air into the attic. They're the part most often missing or blocked, usually by insulation or paint, and no exhaust vent works well without them.

Ridge Vents

A vent along the peak of a shingle roof that lets hot air out along the whole ridge. It works best on roofs with a long ridge.

Off-Ridge & Tile Vents

Low-profile vents set just below the peak. They're used on tile and metal roofs, and on hip roofs, where the ridge is too short for a ridge vent to do the job alone.

Solar Attic Fans

A fan with its own solar panel pulls hot air out while the sun is up. It needs no wiring to the house, and it runs hardest when the attic is hottest.

Gable Vents

Wall vents at the ends of the attic. They help most as part of a balanced system, and many Florida homes with hip roofs don't have gable walls at all.

Turbines

Vents that spin in the wind to pull air out. They do little on a still day, and old ones rust, squeak and leak.

Active Ventilation

Why We Like Solar Star Fans

Passive vents rely on heat rising and on wind. On a still afternoon they can only let out what rises on its own. A fan keeps the air moving. Solar Star attic fans from Solatube run on their own solar panel, so they add nothing to your power bill and need no wiring to the house.

Two sizes. The Solar Star RM 1500 suits smaller attics and garages. The RM 2400 has a larger solar panel for bigger attics.

Made for Florida. Solar Star roof-mount fans have a Florida Product Approval. The high-profile model is approved for Broward's High Velocity Hurricane Zone.

Smart options. A thermal switch turns the fan on only when the attic heats up. ClimaSense models sense heat and humidity and can keep running after sunset. That option uses house power.

What to expect. The Florida Solar Energy Center tested two solar attic fans on a Central Florida home. The peak attic temperature dropped by about 22 degrees, and air conditioning use fell about 6%. That was one house, and yours will differ. The fair takeaway is a much cooler attic and a small effect on the power bill.

Sized to your attic. A fan can only push out as much air as the intake vents let in. We check the attic size and the soffit vents first, so the fan pulls in outside air and not cooled air from your rooms.

  • RM 1500: smaller attics
  • RM 2400: larger attics
  • Solar powered, no wiring
  • Florida Product Approval
Our Process

How We Improve Airflow

  1. 01

    Check the attic

    We look at the vents you have, whether the soffit vents are open or blocked, and signs of heat and moisture.

  2. 02

    Balance it

    We plan intake and exhaust together, so air moves through the whole attic, from the eaves to the peak.

  3. 03

    Install

    Vents and fans go in with the flashing made for your roof type, attached the way their Florida Product Approval says.

  4. 04

    Best timing

    Adding or changing vents is easiest during a re-roof, when the roof is already open, but we can add them anytime.

Good to Know

Don't Mix Exhaust Types

More vents isn't always better. Put a fan near a ridge vent, or a turbine near an off-ridge vent, and the stronger one can pull its air in through the weaker one. Air then loops across the top of the attic and the rest sits still. In a storm, that same pull can draw rain in. One kind of exhaust for each attic space is the safe rule, and it's why we look at what you already have before adding anything.

Vents and Hurricanes

Every vent is an opening in the roof. In a hurricane, wind pushes rain sideways and uphill, and vents are one of the places it gets in. That's why vents and fans used here need a Florida Product Approval, and in Broward an approval for the High Velocity Hurricane Zone. They have to be installed exactly the way that approval says.

Spray Foam Attics

If your attic has spray foam insulation sprayed under the roof deck, it may be built as a sealed, unvented attic. Adding vents to that kind of attic can cause problems, so we check first.

Not sure what you have? We'll look during your free estimate.

Reviews

What Our Customers Say

4.9 Based on 65 Google reviews Read all reviews on Google
“Excellent work from start to finish. The crew was professional, the communication was good, and the roof looks great. Everything was completed as promised, and I am very satisfied with the final result.”
Daniel D.Google review
“The team was professional, punctual, and paid close attention to detail throughout the entire project. They communicated clearly, completed the job on schedule, and ensured the site was spotless afterward.”
Elimar D.Google review
“Great company to work with. Very competitive price, good material & quality work.”
Alvaro M.Google review

Read more reviews

FAQ

Ventilation Questions

Are solar attic fans worth it in Florida?

They do what they're built to do: cool the attic. In a Florida Solar Energy Center test on a Central Florida home, two solar fans cut the peak attic temperature by about 22 degrees and trimmed air conditioning use by about 6%. A solar fan costs nothing to run. The gain is a cooler attic more than a lower power bill. It makes the most sense when the attic is very hot and has enough intake vents, and it won't make up for thin insulation or leaky ducts.

Do solar attic fans work at night?

A standard solar fan runs when the sun is on its panel. That's also when the attic is hottest, so it works when it's needed most. It has no battery. ClimaSense models can keep running after sunset on house power.

How much ventilation does my attic need?

The Florida Building Code sets a minimum vent area based on the size of your attic floor. It works best split between intake down low and exhaust up high. For fans, the choice between the RM 1500 and the RM 2400 depends on the attic's size and how much sun the panel will get. We measure and tell you.

Is a ridge vent better than an off-ridge vent?

It depends on the roof. A ridge vent works well on a shingle roof with a long ridge and open soffit vents. Many Florida homes have hip roofs, where the ridge is short, so off-ridge vents or a fan do more of the work. Tile roofs use off-ridge or tile vents.

Can I add a fan if I already have a ridge vent?

Not without a plan. A fan near a ridge vent can pull its air in through the ridge vent and leave the rest of the attic unvented. Mixing exhaust types is one of the most common ventilation mistakes. We look at what you have and decide which exhaust the attic should rely on.

Do roof vents let rain in during a hurricane?

They can, which is why the choice of vent matters. Vents and fans used here must have a Florida Product Approval, and in Broward an approval for the High Velocity Hurricane Zone, and be installed the way that approval says. That's how we install them. Old turbines and damaged vents are where the trouble usually starts.

Service Area

Where We Work

Palm Beach and Broward County, from Jupiter to Hollywood. Not sure we cover your street? Call and ask.

Palm Beach County Jupiter Palm Beach Gardens West Palm Beach Royal Palm Beach Loxahatchee Wellington Lake Worth Beach Boynton Beach Delray Beach Boca Raton Coral Springs Pompano Beach Fort Lauderdale Hollywood See the full map